Networking

Networking

Prepared by

Sanjo Thomas, CCNA, MCSE, MCDBA

sanjo900@yahoo.com

-1-

Prepared by

Sanjo Thomas, CCNA, MCSE, MCDBA

sanjo900@yahoo.com

-1-

Prepared by

Sanjo Thomas, CCNA, MCSE, MCDBA

sanjo900@yahoo.com

-2-

TCP/IP & Networking Questions
Ethernet Ethernet uses an access method called CSMA/CD. This is a system where each computer listens to the cable before sending anything through the network. If the network is clear, the computer will transmit. If some other node is already transmitting on the cable, the computer will wait and try again when the line is clear. Sometimes, two computers attempt to transmit at the same instant. When this happens a collision occurs. Each computer then backs off and waits a random amount of time before attempting to retransmit. With this access method, it is normal to have collisions. However, the delay caused by collisions and retransmitting is very small and does not normally affect the speed of transmission on the network. The Ethernet protocol allows for linear bus, star, or tree topologies. Data can be transmitted over twisted pair, coaxial, or fiber optic cable at a speed of 10 Mbps. Fast Ethernet To increase transmission speed, the Ethernet protocol has developed a new standard that supports 100 Mbps. This is commonly called Fast Ethernet. Fast Ethernet requires the use of different, more expensive network concentrators/hubs and network interface cards. In addition, category 5 twisted pair or fiber optic cable is necessary. Token Ring In Token Ring, the computers are connected so that the signal travels around the network from one computer to another in a logical ring. A single electronic token moves around the ring from one computer to the next. If a computer does not have information to transmit, it simply passes the token on to the next workstation. If a computer wishes to transmit and receives an empty token, it attaches data to the token. The token then proceeds around the ring until it comes...